Power supply module with a DC input of 19.2 to 72 V that delivers 5 V DC at 4 A and 24 V DC at 0.5 A to the backplane bus on the secondary side. The single-slot module carries LEDs for faults, battery status and output voltages, a button for acknowledging fault messages, a standby switch and, under the cover, a compartment for a backup battery.
General
| Manufacturer | Siemens |
| Type / model | PS 405 4A |
| Article number | 6ES7405-0DA02-0AA0 |
| Order number | 6ES7405-0DA02-0AA0 |
| Series | SIMATIC S7-400 |
| Condition | Used |
Technical data
| Rated input voltage | 24/48/60 V DC |
| Permissible input voltage range | static 19.2 to 72 V DC, dynamic 18.5 to 75.5 V DC |
| Rated input current | 2 A at 24 V, 1 A at 48 V, 0.8 A at 60 V |
| Inrush current | peak value 18 A, full width at half maximum 20 ms |
| Output voltages | 5.1 V DC and 24 V DC |
| Output current 5 V DC | max. 4 A, no base load required |
| Output current 24 V DC | max. 0.5 A, no-load proof |
| Short-circuit protection | yes |
| Mains buffering | > 20 ms at a repeat rate of 1 s, meets NAMUR recommendation NE 21 |
| Power input | typ. 48 W |
| Power loss | typ. 16 W |
| Backup battery (optional) | 1 × lithium AA, 3.6 V/2.3 Ah |
| Backup current | max. 100 µA when power is off |
| Slots occupied | 1 |
| Protection class | I, with protective conductor |
| Overvoltage category | II |
| Protective separation | yes, to IEC 61131-2 |
| Mains connection | 3-pin power connector, 3 × 1.5 mm², solid or stranded wire with end sleeve, cable diameter 3 to 9 mm |
| Controls | FMR button (failure message reset), standby switch (does not cut off mains), BATT INDIC switch (BATT, OFF) |
| Indicators | LEDs INTF, BAF, BATTF, DC 5 V, DC 24 V |
| Operating ambient temperature | 0 to 60 °C |
| Dimensions (W × H × D) | 25 × 290 × 217 mm |
| Weight | approx. 760 g |